Connection For Hayward Heaters - Intermatic PE650 Installation And User Manual

Connection for Hayward Heaters

1.
Remove service door on Heater.
.
Remove
factory-
installed
wire
connector
between
two (2)
red wires
labeled
"CONNECTION FOR FIELD INSTALLED
CONTROL SWITCH."
.
Connect
two #14
gauge
wires,
designed
for use
in hot
environ-
ments, to the two red wires.
.
Wire the other end to the two black
wires, marked heater connection, on the
panel-mounted receiver in your I-Wave
Control Center.
5.
Do not disconnect high limit or pressure
switches.
6.
Turn heater thermostat(s) to max setting.
.
Turn the thermostat selector switch to the
ON, HIGH, or SPA position.
Providing a brighter solution.™
Install Panel-Mounted Transceiver
15