Section 2:
Installing the Panel-
Mounted Transceiver
The Panel-Mounted Transceiver (PE650)
mounts through a hole at the top of the
steel enclosure just above the low voltage
raceway, and — depending on the specifics
of the installation — plugs into the Three-
Circuit Clock Control (P1353ME), Valve-
Pump Switch (P4243ME) mechanisms, or
any combination thereof that are mounted
inside.
Mounting the Unit
If a knock-out is not
present in the steel
enclosure, drill a 1-3/8"
hole in the upper left
corner of the enclosure,
as shown.
Remove knockout
Remove knockout
or drill 1-3/8" hole here
or drill 1-3/8" hole here
Providing a brighter solution.™
Install Panel-Mounted Transceiver
Insert Transceiver
Insert Transceiver
through hole,
through hole,
secure with nut
secure with nut
from below
from below