Intermatic PE650 Installation And User Manual page 47

If it doesn't
work
Results of
trouble-
shooting
Check for successful wireless reception
all around the yard
What to do
1.
Wake up the Hand-Held Remote by pressing any
button.
.
Identify and walk to the areas where you intend to
use the Hand-Held Remote, and make sure you see
STAT OK in the upper left corner of the display at all
times in these areas.
.
If the word OK disappears and the display reads
only STAT, follow the procedures in the next
column.
If you can't complete this procedure successfully, follow
the steps below to troubleshoot.
If it doesn't
work
Verify that
the Hand-
Held Remote
is working
properly.
Check Out and Troubleshooting
Reference/Procedure
1.
If the heater does not work
independently of the control,
repair the heater.
.
If the heater does work
independently of the control,
replace the Panel-Mounted
Transceiver. See page 4 for
ordering information.
Reference/Procedure
Follow the troubleshooting
procedures on page 42.
Providing a brighter solution.™