Calibrating The Temperature Display - Intermatic PE650 Installation And User Manual

0
I-Wave PE950/PE650 Installation Guide
The owner can add up to 5 Hand-Held
Controllers to a system.

Calibrating the Temperature Display

If the homeowner is using a floating
thermometer or other device to measure
water temperature, there may be discrepancy
between that device and the temperature
shown on the Hand-Held Remote.
Use the following procedure to calibrate the
temperature display on the Hand-Held
Remote to match that of another device.
1.
Press and release
any button on the
Hand-Held Remote
to wake it from
sleep. (The unit
goes to sleep to conserve battery life
when it has been idle for 30 seconds.)
.
Press and hold the
<P/S> and
<CHLR> buttons at
the same time for
about 5 seconds.
This will put the device in programming
mode, as shown.
.
Press and release
the <5> button
to select MORE
OPTIONS. A new
screen will appear,
as shown.
Copyright © 2006 Intermatic, Inc.
72 72
STAT STAT
OK OK
POOL POOL
LEA RN LEA RN VER P VER P
1 1 INC LUDE NO DE INC LUDE NO DE
2 2 ADD TO ADD TO GROUP GROUP
3 3 RES ET N ODE RES ET N ODE
4 4 RES ET C ONTROLLE R RES ET C ONTROLLE R
5 5 MOR E OP TIO NS MOR E OP TIO NS
C C EXI T EXI T
LEA RN LEA RN VER x VER x
1 1 BOOSTER BOOSTER
2 2 ADD NEW CO NTROL LER ADD NEW CO NTROL LER
3 3 ADJ UST TEMP 0 ADJ UST TEMP 0
5 5 PRE VIOU S O PTION S PRE VIOU S O PTION S
C C EXI T EXI T
ºF SET ºF SET
P 72 P 72
S 85 S 85