Intermatic PE650 Installation And User Manual page 44


I-Wave PE950/PE650 Installation Guide
If it doesn't
work
Verify that the
Hand-Held
Remote is
successfully
linked up to
the Panel-
mounted
Transceiver.
Verify that the Hand-Held Remote is
controlling pool and spa temperature
What to do
1.
Wake up the Hand-Held Remote by pressing any
button.
.
Depending on how your suction and discharge
valves are turned, the display should show the actual
water temperature of either the pool or spa.
.
On the right hand side of the display there should
be a P and S indicating the pool and spa set
temperatures. Press the <ARROW> buttons to adjust
the set point so that it is higher then the actual water
temperature.
.
Verify that the word HEATING appears at the bottom
of the display. This indicates that the heater should
be heating, if it is working properly and the system is
wired and plumbed properly.
5.
Verify that the heater is actually heating.
Reference/Procedure
1.
Check that the display panel on
the Hand-Held Remote says STAT
OK, not just STAT.
.
If not, reprogram the Hand-Held
Remote. See pages 20-25.
.
Replace the Hand-Held Remote if
unable to successfully program.
.
Replace the Panel-Mounted
Transceiver if still not able to
establish communication with the
replacement Hand-Held Remote.
Copyright © 2006 Intermatic, Inc.