10
I-Wave PE950/PE650 Installation Guide
Connecting a Heater (optional)
Refer to page 32 of this manual for
information concerning setting the
temperatures for both your pool and spa.
•
Drill a 3/8" hole in the pipe between
the filter pump and filter and install the
Water Temperature Sensor with hose
clamp (not provided). Ensure the O-ring
is in place.
•
Run the wire to the Control Center,
through the low voltage raceway.
Connect both wires to the Panel-Mounted
Receiver. See the diagram below.
The Intermatic I-Wave PE650 and
PE950 wireless components can control
most heaters or heat pumps that use
thermostatic circuitry of 24 VAC @ 2A or
Copyright © 2006 Intermatic, Inc.