Intermatic PE650 Installation And User Manual page 36

6
I-Wave PE950/PE650 Installation Guide
The PRIMARY controller must be used
to "introduce" or link any additional
(SECONDARY) Hand-Held units to the
Control Center.
If the PRIMARY controller must be replaced
(due to loss, damage, etc.,), you must
reprogram from scratch to create a new
PRIMARY controller, then reprogram any
additional controllers as SECONDARY
controllers.
1.
Press and release
any button on the
Hand-Held Remote
to wake it from
sleep. (The unit
goes to sleep to conserve battery life
when it has been idle for 60 seconds.)
The screen display on the Hand-Held
should look generally like the example
shown.
.
On both Hand-
Held units, press
and hold the <P/
S> and <CHLR>
buttons at the same
time for about 5 seconds to put them into
programming mode, as shown.
Copyright © 2006 Intermatic, Inc.
72 72
STAT STAT
OK OK
POOL POOL
LEA RN LEA RN VER P VER P
1 1 INC LUDE NO DE INC LUDE NO DE
2 2 ADD TO ADD TO GROUP GROUP
3 3 RES ET N ODE RES ET N ODE
4 4 RES ET C ONTROLLE R RES ET C ONTROLLE R
5 5 MOR E OP TIO NS MOR E OP TIO NS
C C EXI T EXI T
ºF SET ºF SET
P 72 P 72
S 85 S 85