Intermatic PE650 Installation And User Manual page 27

Setting Up Hand-Held Remote Transceiver
Repeaters can relay signals to bridge
between a dead spot and the Control Center.
NOTE: The relay between Repeaters and the
rest of the system causes a delay in response
time. Wait a few seconds for commands you
enter on the Hand-Held Remote to register.
1.
Plug a Transceiver Repeater Module
(HA04C), available from Intermatic, into
any electrical outlet that is located where
you have determined a reception
problem can be solved.
.
If necessary, press
and release any
button on the
Hand-Held Remote
to wake it from
sleep. Because you are at a location
in between the control center and the
problem area, the screen display on the
Hand-Held will look generally like the
example shown.
.
Press and hold the
<P/S> and <CHLR>
buttons at the same
time for about 5
seconds. This will
put the device in programming mode, as
shown.
Providing a brighter solution.™
72 72
STAT STAT
OK OK
POOL POOL
LEA RN LEA RN VER P VER P
1 1 INC LUDE NO DE INC LUDE NO DE
2 2 ADD TO ADD TO GROUP GROUP
3 3 RES ET N ODE RES ET N ODE
4 4 RES ET C ONTROLLE R RES ET C ONTROLLE R
5 5 MOR E OP TIO NS MOR E OP TIO NS
C C EXI T EXI T

ºF SET ºF SET
P 72 P 72
S 85 S 85