Intermatic PE650 Installation And User Manual page 43

If it doesn't
work
Verify that
batteries are
installed
properly and
fully charged.
Verify that the
Hand-Held
Remote has
successfully
awakened
from its sleep
state.
Check Out and Troubleshooting
Reference/Procedure
1.
The Hand-Held Remote takes
3 AAA batteries. Make sure the
batteries are installed and are
properly aligned according to the
polarity markings in the battery
compartment.
.
Do not mix fully charged batteries
with partially charged batteries in
the Hand-Held Remote.
.
Do not use rechargeable batteries
in the Hand-Held Remote.
.
If the Low Bat indicator is
visible in the display, the Hand-
Held Remote will function
intermittently. Replace batteries
immediately.
1.
Push any button on the Hand-
Held Remote to wake it from its
sleep state. Failure to awaken
means there will be nothing
visible on the display!
.
If the Hand-Held Remote is
awake and none of its buttons are
pressed, it should go back into its
sleep state after one minute.
Providing a brighter solution.™