Intermatic PE650 Installation And User Manual page 37

Setting Up Hand-Held Remote Transceiver
.
On the NEW Hand-Held you are adding
to the network:
a.
Press and
release the <5>
button to select
MORE
OPTIONS. A
new screen will appear, as shown.
b.
Press and
release the <2>
button on the
new screen to
select READY
FOR ADD. The
screen refreshes and displays only the
line 2 READY TO ADD.
.
Promptly, on
the EXISTING or
PRIMARY Hand-
Held that is already
part of the network,
press and release the <1> button to select
INCLUDE NODE. After a few seconds,
the word SUCCESS should appear on the
screens of both units.
5.
Press and release the <CHLR> button
on both Hand-Held Controllers to exit
programming mode. The left side of the
screen of both Controllers will say STAT
OK, indicating that the procedure has
been successful.
Providing a brighter solution.™
LEA RN LEA RN VER x VER x
1 1 BOOSTER BOOSTER
2 2 ADD NEW CO NTROL LER ADD NEW CO NTROL LER
3 3 ADJ UST TEMP 0 ADJ UST TEMP 0
5 5 PRE VIOU S O PTION S PRE VIOU S O PTION S
C C EXI T EXI T
LEA RN LEA RN VER x VER x
2 2 ADD NEW CO NTROL LER ADD NEW CO NTROL LER
LEA RN LEA RN VER x VER x
1 1 INC LUDE NO DE INC LUDE NO DE
2 2 ADD TO ADD TO GROUP GROUP
3 3 RES ET N ODE RES ET N ODE
4 4 RES ET C ONTROLLE R RES ET C ONTROLLE R
5 5 MOR E OP TIO NS MOR E OP TIO NS
C C EXI T EXI T
SUC CES S SUC CES S