Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
6.27
40
D00075-10
Adjusting the steering head bearing play
-
Press the new bearing ring up to the stop with special
tool @) .
Tool bracket (58429089000)
Pressing tool (58429091000)
-
Remove lower steering head bearing
-
Remove the seal ring.
-
Grease and mount the new seal ring.
-
Press on the new bearing with a suitable tube as far as it will
go.
Finishing work
-
Install the lower triple clamp.
-
Install front fender.
(!,JI
p. 108)
-
Install the start number plate.
-
Install the front wheel.
(a
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
-
Mount the handlebar cushion.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
Main work
O.
-
Loosen screws
8.
Remove screw
Loosen and retighten screw @) .
Guideline
Screw, top steering
head
-
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
O.
-
Tighten screws
Guideline
Screw, top triple
clamp
(a
p. 287)
(0
p. 287)
0.
(!,JI
p. 36)
(a
p. 109)
p. 113)
(a
p. 38)
(il!,!l
p. 12)
(0
p. 12)
M20x1.5
12 Nm (8.9 lbf ft)
M8
17 Nm (12.5 lbf ft)
Advertisement
Table of Contents
