Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
74
Remove the screw from the filling port.
Mount adapter
•
Info
I
Hand-tighten only without using a tool.
Connect adapter
I Vacuum pump (T1240S)
-
Clamp the damper with soft jaws or hold it as shown in the
figure.
•
Info
I
Only clamp the damper lightly.
The filling port must be located at the highest position.
The piston rod moves in and out during filling; do not
immobilize it by holding it with your hand.
-
Clamp the control lever as shown in the figure.
✓ Control lever
Damper
set to
-
Activate
On/Off
✓ The suction process begins.
✓ Pressure gauge @ drops to the required value.
I < 0 bar
✓ Vacuum gauge Q) drops to the required value.
14
mbar
Determine distance
reservoir hole with the special tool.
I Depth micrometer (T107S)
✓ The floating piston is located in the lowermost position.
-
-1
1
_!
802085-10
-
When the vacuum gauge reaches the required value, turn
control lever
Guideline
14
mbar
✓ The pressure gauge increases to the required value.
0 bar
O
on the damper.
O
to connector @ of the vacuum pump.
(0
p. 298)
(D
is set to
External tank
8
is set to
and
Vacuum
Vacuum.
switch (D.
O
between the floating piston and
(�
p. 296)
0
Oil reservoir
to Equalize pressure.
Closed,
C,
is
Oil reservoir
Advertisement
Table of Contents
