Table of Contents
Advertisement
17 ENGINE
17 .4.12
17.4.13
17.4.14
192
Installing the drive wheel of the balancer shaft
310342-10
Cylinder - Nikasil
®
coating
310368-10
Checking/measuring the cylinder
310346-10
-
Ensure that woodruff key
8
-
Warm drive wheel
of the balancer shaft and push it onto
the balancer shaft.
Guideline
1100 °C (212 °F)
is a surface protection layer for a coating procedure
®
Nikasil
developed by Mahle. The name is derived from the two materials
used in this procedure - a layer of nickel into which is embedded
the particularly hard silicone carbide.
The most important advantages of the
good heat conductivity, resulting in much improved performance,
low wear, and a lightweight cylinder.
-
Check the cylinder bearing surface for damage.
If the cylinder bearing surface is damaged:
-
Change the cylinder and piston.
-
Measure the cylinder diameter at several locations on
the 0- and 0-axes using a micrometer to identify oval
wear.
Guideline
Cylinder - drill hole diameter
Size I
Size II
Info
The cylinder size
-
Using a straightedge and the special tool, check the sealing
area of the cylinder head for distortion.
I Feeler gauge (59029041100)
Cylinder/cylinder head -
distortion of sealing area
If the measured value does not meet specifications:
-
Change the cylinder.
O
is seated properly.
coating are very
®
Nikasil
78.000 ... 78.012 mm
(3.07086 ... 3.07133 in)
78.012 ... 78.025 mm
(3.07133 ... 3.07184 in)
O
is marked on the cylinder collar.
(a
p. 288)
:e; 0.10 mm (:e; 0.0039 in)
41
41
Advertisement
Table of Contents
