Husqvarna FC 250 2016 Repair Manual page 138

16 BRAKE SYSTEM
136
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
O.
Remove screws
8
Remove cover with membrane
Manually press the brake caliper to the brake disc to push
back the brake pistons. Ensure that brake fluid does not flow
out of the brake fluid reservoir, extracting it by suction if it
does.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis­
tons.
8,
Remove cotter pins
brake linings.
-
Clean the brake caliper and brake caliper support.
-
Check that leaf spring (3 in the brake caliper and sliding
plate @ in the brake caliper support are seated correctly.
Insert the new brake linings, insert pin @), and mount cotter
8.
pins
• Info
I
Always change the brake linings in pairs.
-
Operate the hand brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point.
C,.
pull out pin @), and remove the