Table of Contents
Advertisement
-
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
-
Cover the painted parts.
O.
-
Remove screws
8
-
Remove cover
with membrane.
-
Draw the old brake fluid out of the brake fluid reservoir using
a syringe and fill with fresh brake fluid.
Syringe (50329050000)
Brake fluid DOT 4
(llill
p. 280)
-
Mount bleeder cover@).
I
Bleeder cover (00029013005)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
8-
-
Open shut-off valve
•
Info
I
Follow the operating instructions of the bleeding
device.
-
Ensure that the inflation pressure is correctly set at pressure
gauge f). If necessary, adjust the inflation pressure at pres
sure regulator G).
I
Guideline
Inflation pressure
0
-
Pull off protection cap
Connect the hose of the bleeder bottle.
I
Bleeding device (00029013100)
(D
-
Open bleeder screw
•
Info
I
Bleed until fresh brake fluid emerges from the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
8-
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
•
Info
I
This prevents overfilling of the brake fluid reservoir.
-
Tighten the bleeder screw. Remove the hose of the bleeder
bottle. Mount the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
16
BRAKE SYSTEM
(�
p. 286)
(�
p. 284)
(�
p. 284)
I
2 ... 2.5 bar (29 ... 36 psi)
of the brake caliper bleeder screw.
(�
p. 284)
by approx. one half turn.
141
Advertisement
Table of Contents
