Table of Contents
Advertisement
16 BRAKE SYSTEM
148
8.
-
Mount bleeder cover
I Bleeder cover (00029013006)
-
Connect the bleeding device.
I Bleeding device (00029013100)
8.
-
Open shut-off valve
•
Info
I
Follow the operating instructions of the bleeding
device.
-
Ensure that the inflation pressure is correctly set at pressure
O.
gauge
If necessary, adjust the inflation pressure at pres
G,.
sure regulator
Guideline
I Inflation pressure
8
-
Pull off protection cap
hose of the bleeder bottle.
I Bleeding device (00029013100)
0
-
Open bleeder screw
Info
Bleed until fresh brake fluid emerges from the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
8.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
•
Info
I
This prevents overfilling of the brake fluid reservoir.
-
Tighten the bleeder screw. Remove the hose of the bleeder
bottle. Mount the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
-
Stand the vehicle upright.
-
Correct the brake fluid up to marking (!).
I Brake fluid DOT 4
(�
p. 280)
-
Mount and tighten the screw cap with the membrane and 0-
ring.
(�
p. 284)
(�
p. 284)
I 2 ... 2.5 bar (29 ... 36 psi)
of the bleeder screw. Connect the
(�
p. 284)
by approx. one-half turn.
Advertisement
Table of Contents
