Table of Contents
Advertisement
14 WHEELS
•
14.6.3
114
H00935-10
Changing the front brake disc
Info
If the brake discs are changed, the brake linings must also be changed.
-
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
-
Change front wheel bearing.
-
Clean and grease shaft seal rings
surfaces
of the spacers.
6)
I Long-life grease
(0
p. 282)
-
Insert the spacers.
-
Clean and grease the wheel spindle.
I Long-life grease
(0
p. 282)
-
Position the front wheel and insert the wheel spindle.
✓ The brake linings are correctly positioned.
-
Mount and tighten screw
Guideline
Screw, front wheel
spindle
-
Operate the hand brake lever several times until the brake
linings are seated correctly against the brake disc.
Remove the motorcycle from the lift stand.
-
Operate the front brake and compress the fork a few times
firmly.
✓ The fork legs straighten.
-
Tighten screws (D.
Guideline
I Screw, fork stub
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the front wheel.
Main work
-
O.
Remove screws
Remove the brake disc.
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
Screw, front
M6
brake disc
Finishing work
-
Install the front wheel.
(0
(0
p. 115)
O
and contact
@.
M20x1.5
35 Nm (25.8 lbf ft)
(0
p. 12)
15 Nm (11.1 lbf ft)
1
(0
p. 12)
(�
p. 112)
O.
14 Nm (10.3 lbf ft)
Loctite
p. 113)
..
®
243™
Advertisement
Table of Contents
