Table of Contents
Advertisement
11.12
Adjusting steering head bearing play
SERVICE WORK ON THE CHASSIS 11
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear-
ing.
»
If there is detectable play:
–
Adjust steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
H01167-01
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
»
If detent positions are detected:
–
Adjust steering head bearing play.
–
Check the steering head bearing and adjust if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
S03017-10
to avoid stresses.
–
Mount and tighten screw
Guideline
Screw, top
steering stem
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Check steering head bearing play. (
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. (
p. 44)
1
.
2
.
3
.
M20x1.5
12 Nm (8.9 lbf ft)
2
.
M8
20 Nm (14.8 lbf ft)
1
.
M8
17 Nm (12.5 lbf ft)
p. 50)
(
p. 51)
(
p. 51)
p. 44)
®
Loctite
243™
p. 44)
51
Advertisement
Table of Contents
