Adjusting The Steering Head Bearing Play; Lubricating The Steering Head Bearing; Tighten Screw; Screw, Top Steering M20X1.5 - Husqvarna FC 450 Rockstar Edition 2022 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.16
11.17
58

Adjusting the steering head bearing play

A01075-10

Lubricating the steering head bearing

H02387-01
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
1
Loosen screws .
–
2
Remove screw .
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–

Using a plastic hammer, tap lightly on the upper triple clamp

to avoid stresses.

–
Mount and tighten screw
Guideline
Screw, top M8

steering stem

–
1
Tighten screws .
Guideline
Screw, top triple
clamp
–
Check the steering head bearing for play. (
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
p. 48)
3
.
M20x1.5 12 Nm (8.9 lbf ft)
2
.
20 Nm (14.8 lbf ft)
Loctite
M8 17 Nm (12.5 lbf ft)
p. 57)
p. 48)
( p. 54)
( p. 55)
®
243™