Linux Upgrade To New Firmware - Western Digital Ultrastar ScaleUp SE4U102 User Manual

Table of Contents

Advertisement

User Guide
b. After connecting the Ethernet interfaces and obtaining the IP addresses via DHCP, locate
the
c. Verify that both OOBMs have IP addresses by issuing the command
d. Locate the IP addresses in the Enclosure Services Controller Electronics (ESCE) elements,
indicated by the
Element type: Enclosure services controller electronics, subenclosure id:
0 [ti=5]
Overall descriptor: <empty>
Element 0 descriptor: ESCE IOMA,IOM PART NUM ,IOM SERIAL
NUM,5000CCAB0500003C,XXX.XXX.XXX.XXX
Element 1 descriptor: ESCE IOMB,IOM PART NUM ,IOM SERIAL
NUM,5000CCAB0500007C,XXX.XXX.XXX.XXX
4.3.4   Linux Upgrade to New Firmware
To download the new firmware package, do the following:
Step 1 : Ensure multi-pathing can see all of the expected drives.
a. Execute the following command to verify that there are two paths to each drive:
multipath -ll | grep -i "active ready running" -c
Step 2 : Locate the <dev> device name from the sg_scan -i.
Step 3 : In the terminal, type:
sg_ses_microcode <dev> -m 0xe -N -b 4096 -I <filename> -vv
Step 4 : Press Enter.
The firmware begins loading onto the IOMs. The upgrade can take up to 20 minutes to
complete.
device name from the
<dev>
XXX.XXX.XXX.XXX
Important: Do not unzip/extract the tar.gz file. Doing so will result in errors during
the firmware upgrade process.
Important:
Due to the firmware image being a .tar.gz file, the enclosure has to unpack and
load the firmware onto the respective ICs which may take up to 15 minutes.
Once the sg_ses_microcode command is issued wait 20 minutes to ensure the
enclosure has time to perform this process. To check the status of this process,
use the Redfish out-of-band management to make a GET request to the following
target:
curl -G
-k -u admin:admin -H "Content-type: application/
json" https://<ip address>/redfish/v1/UpdateService/Actions/
UpdateService.SimpleUpdate/Status
Note:
output from step
sg_scan -i
in the results, as shown in the following example:
4. Management
4.3 Firmware Upgrade
2 (page
201).
sg_ses <dev> -p0x7
.
202

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ultrastar data1021ex1231

Table of Contents