User Guide
Figure 251: Minimum HDD Partial Population
4.9.2 Installing Drives
This section provides steps on how to install drives into the enclosure. The enclosure is shipped with
a minimum of 60 HDDs. Before beginning the process of adding drives, refer to the
Configurations (page 253)
that configuration.
Step 1 : Grasp both handles at the front of the enclosure and pull with even pressure to extend the
chassis out of the rack until it is stopped by the safety latches. The safety latches will prevent
the enclosure from coming out of the rack completely and the cover will remain in the rack
attached to the rear alignment brackets.
Figure 252: Chassis Handle Operation
Step 2 : Locate the area that the new drives will be installed into.
Step 3 : Follow the requirements for partial populations listed in
253).
section to determine what configuration will be used and what is required of
4. Management
4.9 Partially Populated Enclosures
Partial Population
Partial Population Configurations (page
254