Western Digital Ultrastar ScaleUp SE4U102 User Manual page 199

User Guide
k. If the Ultrastar Data102 is being installed in a rack and will subsequently be transported
inside that rack, it is important to use the included cable tie to wrap the CMA bundle to
ensure it does not get damaged during transport. If the Ultrastar Data102 is instead being
installed where it will be operated, skip this step. Remember to remove the cable ties after
the enclosure has reached its final operational location.
l. Reconnect the arm at the elbow to the connectors on the rail.
CMA Lite:
a. Press the blue latch button labeled "push" to unlatch the elbow side of the CMA arm, and
then swing the arm open.
b. Open all of the baskets.
Figure 224: Open Baskets
c. Gather the SAS, power, and Ethernet cables for installation.
d. Connect the Ethernet cables to the Ethernet ports on the left hand side of the Ultrastar
Data102 , and then route the cables through each of the baskets on the arm.
Note: Route all cables to IOM A (left hand side looking at the rear).
3. Support
3.9 Chassis Replacement
183