Western Digital Ultrastar ScaleUp SE4U102 User Manual page 266

User Guide
Host 4 : 68-84
Host 5 : 85-101
R esult: T he zoning status for each IOM should match the configuration from the file sent to the enclosure
in step 3 (page 248).
4.7.8.4 Disabling File-Based Zoning Using Windows
This task provides instructions for disabling zoning and/or disabling the file-based zoning feature in a
Windows operating system environment.
Step 1 : From a command line, use the
connected to the host:
C:\> sg_scan -s | findstr -i H4102
From the output,note the device names for the IOMs (i.e.
SCSI3:0,84,0
SCSI3:1,29,0
Step 2 : Use the
Clear_Config.bin
C:\> sg_ses_microcode SCSI3:0,84,0 -m0xe -b 4096 -N -I H4102-
J_Zoning_Clear_Config.bin
Step 3 : Use the
C:\> sg_ses_microcode SCSI3:0,84,0 -m0xf
After the file is activated, the SAS connectors will be cycled off and on, triggering the host to
perform discovery.
Note: Depending on which binary file was used, either zoning is now disabled or the
file-based zoning feature itself is now disabled. The remaining steps in this task are for
verification purposes and require the WDDCS Tool. For instructions on disabling file-based
zoning using only the WDDCS Tool, please see the WDDCS Tool User Guide.
Step 4 : Use the WDDCS Tool's
C:\> wddcs show
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: SCSI3:0,84,0
product : H4102-J
serial
firmware: 2050-028
name
Device: SCSI3:1,29,0
product : H4102-J
sg_scan
claimed=0 pdt=dh
claimed=0 pdt=dh
utility to send the binary file (either
sg_ses_microcode
) to the enclosure through any of the IOM SEP handles:
Note: In this example, the
utility to activate the file:
sg_ses_microcode
command to view the SEP device handles:
show
: USWSJ02819EZ0012
: Ultrastar Data102
and commands to list the enclosure devices
findstr
SCSIX:X:X:X
HGST H4102-J 2050
HGST H4102-J 2050
file is being used.
Clear_Config.bin
4. Management
4.7 Zoning
):
or
Disable_Config.bin
250