Western Digital Ultrastar ScaleUp SE4U102 User Manual page 141

User Guide
Figure 136: Rack Latch Bracket Installed
b. Use 6 of the included M5 x 12mm screws and the T15 Torx screwdriver to install each bracket,
3 screws per bracket.
Caution: Always install the top cover onto the enclosure before installing the chassis into a
rack. Not having the top cover installed may damage the alignment brackets.
Step 24 : Install the chassis into the rails.
a. Extend the bearing plates on the inside of the mid-rails until they are fully forward (detent
has engaged). This prevents potential damage due to improper mating of the rails.
3. Support
3.8 Rails Replacement
125