Upgrading Configuration From Eight To 16 2.5-Inch Hdds/Ssds - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
For the cable plan, see
Concluding steps
▶ If applicable,
"Installing the SAS expander board" on page
▶
"Installing the system fan in the air duct" on page
▶ Insert all HDD/SSD modules, see
page 185.
Ensure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
7.5.6 Upgrading configuration from eight to 16 2.5-inch
HDDs/SSDs
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
CAUTION
All data on all HDDs/SSDs in the array will be lost when deleting the
RAID array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see the "ServerView Suite RAID
Management" user guide.
After installing or removing an additional backplane, never forget to
change the system information using the Chassis ID Prom Tool.
236
"Appendix B" on page
"Installing 3.5-inch HDD modules" on
66.
79.
81.
Upgrade and Maintenance Manual
519.
268.
284.
Hardware: 20 minutes
Software: 10 minutes
TX1330 M4