Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 274

Hard disk drive (HDD) / solid state disk (SSD)
▶ Remove the intrusion switch cable from the cable clamp (1).
▶ Remove the knurled screw (see circle).
▶ Slide the SAS expander board holder in the direction of the arrow and take it
out of the chassis.
▶ Disconnect all cables from the expander board.
Removing the SAS expander board
Figure 169: Removing the SAS expander board
▶ Remove one screw (see circle).
▶ Push the SAS expander board in the direction of the arrow.
▶ Take off the SAS expander board from the SAS expander board holder.
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Resuming BitLocker functionality" on page
274
66.
79.
81.
Upgrade and Maintenance Manual
121.
TX1330 M4