Indicator On Hot-Plug Psu - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that
supports transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
The separate management LAN connector is used as a management
interface (iRMC S5) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC
S5 server management.
17.2.3.4

Indicator on hot-plug PSU

Figure 339: PSU status indicator
1 PSU status indicator
PSU status indicator (1)
Status
flashing green
green on
flashing orange
TX1330 M4
①
Description
The server is switched off, but mains voltage is present
(standby mode).
The server is switched on and operating properly.
An overload has been detected. The PSU is still running,
but failure might be imminent.
Upgrade and Maintenance Manual
Appendix A
511