Minimum Startup Configuration - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Appendix A
17.4

Minimum startup configuration

Field Replaceable Units
(FRU)
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Component
System board
1 CPU with CPU heat
sink
1 memory module
Front panel module
PSU
Table 6: Minimum startup configuration - components
Cable
Front panel cable
Power cable
Table 7: Minimum startup configuration - cables
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ Take the system down to its minimum startup configuration.
▶
"Connecting the power cord" on page
▶ Connect a display to the server.
▶ Switch on the server, see
516
Notes
no TPM, expansion cards or M.2 SSD installed
installed in CPU 1
installed in DIMM slot 1A
Standard PSU or hot-plug PSU installed in bay
PSU 1
Notes
connected to the system board
47.
79.
"Switching on the server" on page
Upgrade and Maintenance Manual
48.
81.
TX1330 M4