Concluding Steps; Upgrading Configuration From Up To Four Up To Eight 2.5-Inch Hdds/Ssds - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)
Ê Run the OOB cable as shown.
I
For the cable plan, see chapter
7.4.7.5

Concluding steps

Ê Insert all HDD/SSD modules, see section
modules" on page
I
Ensure that you install the HDD/SSD module in the bay it was located
before the HDD backplane replacement.
"Installing the HDD fan module" on page 167
Ê
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 60
Ê
"Switching on the server" on page 63
Ê
7.4.8 Upgrading configuration from up to four up to
eight 2.5-inch HDDs/SSDs
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
All data on all HDDs/SSDs in the array will be lost when deleting the
RAID array! Be sure to back up your data before deleting a RAID array.
For more information, see the "ServerView Suite RAID Management"
user guide.
I
After installing or removing an additional backplane, never forget to
change the system information using the Chassis ID Prom Tool.
158
"Appendix B" on page
144.
Upgrade and Maintenance Manual
341.
"Installing 2.5-inch HDD/SSD
Hardware: 10 minutes
TX1320 M4