Mitsubishi Electric MELSEC iQ-F Series User Manual page 77

Extension connector type
■Input/output connection type: Connector
[1]
(Unit: mm)
No. Name
[1] Extension connector
[2] PWR/POWER LED
[3] I/O display LED
[4] I/O connectors
[5] DISP switch
[6] Extension connector
■Input/output connection type: Spring clamp terminal block
[1]
(Unit: mm)
No. Name
[1] Extension connector
[2] PWR/POWER LED
[3] I/O display LED
[4] Terminal
[5] Extension connector
13
W
[2]
[3]
[4]
[4]
[5]
Description
Connector connected to extend modules
Indicates whether the input modules/output modules are powered or not.
On: Powered
Off: Not powered or hardware error
Turns on when input or output is on.
Connector for connecting input signal cables or output signal cables
For details on the terminal layout, refer to Page 123 I/O Module.
Switches between the display of lower/higher numbers of the input display LED or output display LED.
Lower number: F
Higher number: L
Connector for connecting the extension connector of an extension module
19.7
W
[2]
[3]
[4]
[4]
[3]
Description
Connector connected to extend modules
Indicates whether the input modules/output modules are powered or not.
On: Powered
Off: Not powered or hardware error
Turns on when input or output is on.
Terminals for input, and output.
For details on the terminal layout, refer to Page 123 I/O Module.
Connector for connecting the extension connector of an extension module
74
[6]
74
[5]
3 PART NAMES
3.2 I/O Module
3
75