Inserting And Removing The Sd Memory Card - Mitsubishi Electric MELSEC iQ-F Series User Manual

14.4

Inserting and Removing the SD Memory Card

The following explains insertion and removal of the SD memory card.
Insertion procedure
Mount the SD memory card. Pay attention to its direction and follow the procedure below.
■FX5S CPU module
To use an SD memory card for the FX5S CPU module, an SD memory card module (FX5-SDCD), which is sold separately, is
required.
Power off the FX5S CPU module and connect an FX5-SDCD.
For details on mounting an FX5-SDCD, refer to Page 155 Connection of an expansion board (SD memory card module).
(2)
(1)
14 PROCEDURES BEFORE OPERATION
234
14.4 Inserting and Removing the SD Memory Card
1.
Open the SD memory card slot cover (1).
2.
Check that the SD memory card stop switch of the FX5-
SDCD is on the ON side (down).
3.
Ensure that the notched edge of the SD memory card is
facing upward, and insert it straight into the SD memory
card slot. After mounting, check that the SD memory
card is mounted completely. When it is mounted
incompletely, malfunctions may occur because of poor
contact.
4.
Close the SD memory card slot cover (1).
5.
Power on the FX5S CPU module when the power is off.
6.
The CARD LED (2) blinks until the SD memory card
becomes available.
7.
The CARD LED (2) turns on when the SD memory card
is available.
8.
When the CARD LED does not turn on even though the
SD memory card is mounted, ensure that SM606 (SD
memory card forced disable instruction) and SM607 (SD
memory card forced disable status flag) are off by using
the engineering tool.