Sd Memory Card; Operation For Inserting An Sd Memory Card; Operations For Removing Or Reinserting An Sd Memory Card - Mitsubishi Electric MELSEC iQ-R Series User Manual

4.2

SD Memory Card

This section shows an SD memory card inserted in a high speed data communication module.
For supported SD memory cards and considerations, refer to the following:
Page 57 SD memory card (sold separately, required)
Page 10 Considerations for using an SD memory card

Operation for inserting an SD memory card

Follow the procedure below to insert an SD memory card.
1.
Insert an SD memory card. (Page 53 Insertion procedure)
2.
Turn the power of a CPU module ON when it is OFF.
3.
Check if the SD memory card is correctly inserted into the high speed data communication module. (If the CARD RDY
LED is ON, it is correctly inserted.)
The SD memory card insertion status can be checked with the input signal.
If 'SD memory card status' (X1) is ON, the SD memory card has been correctly inserted.

Operations for removing or reinserting an SD memory card

Follow the procedure below to remove or reinsert an SD memory card. Also, make sure to stop file access before removing
the SD memory card.
Removing
1.
Turn the power of a CPU module ON when it is OFF.
2.
Stop file access to prohibit reading/writing to an SD memory card. (Page 52 Method for stopping file access)
3.
Remove the SD memory card. (Page 53 Removal procedure)
Reinserting
1.
Perform the operation for removing. (Page 50 Removing)
2.
Reinsert an SD memory card. (Page 53 Insertion procedure)
3.
Check if the SD memory card is correctly inserted into the high speed data communication module. (If the CARD RDY
LED is ON, it is correctly inserted.)
4.
Execute "Update settings" in Configuration Tool.
*1 For details on "Update settings," refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
If an error occurs on an SD memory card, refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
Precautions
High speed data communication module settings are saved on an SD memory card. Therefore, the IP address of the high
speed data communication module returns to the initial status (192.168.3.3) when turning the power OFF and ON or resetting
a CPU module without an SD memory card inserted in the module or without the settings written to the SD memory card.
As necessary, read the current settings before removing the SD memory card, and promptly write those settings to the new
card after replacing the card.
4 PROCEDURES BEFORE OPERATION
50
4.2 SD Memory Card
*1