Fluke 5730A/03 Operator's Manual page 83

9. The display now shows the amplitude of the entry. If an entry error is made, push 
to clear the display, then reenter the value. If the most recent digit entered is in error,
push  to clear that digit. The illustration of the display below assumes an entry of
20 dBm:
4/14/2013
Standby
20dBm
10. With the numeric keypad, enter a frequency, followed by  or  if necessary.
The display now shows the amplitude and frequency of the entry. If an entry error is
made, push  to clear the display, then reenter the value. If the most recent digit
entered is in error, push  to clear that digit. The display shown below assumes an
entry of 21 MHz:
4/18/2013
Standby
20dBm 21MHz
13:40
+/- 1.37 % (1 year) 213 days since calibration
Auto Range 1.1 mV
350.00
1.0000
42.00000
dBm
1.0000
kHz
13:40 +/- 1.37 % (1 year) 213 days since calibration
Auto Range 1.1 mV
350.00
1.0000
42.00000
dBm
1.0000
kHz
Front-Panel Operation
μV
kHz
Wideband Setup
Menu
ON
μV
kHz
Wideband Setup
Menu
ON
4
Set the Output
hhp125.eps
hhp126.eps
4-27