Fluke 5730A/03 Operator's Manual page 216

5730A
Operators Manual
835 Cannot Use Ext Sense On Selected Range
836 Cannot Use 2-Wire Comp On Selected Range
837 Cannot Lock This Range
838 Cannot Set Clock, Cal Is Secured
839 Cannot Fmt EEPROM, Cal Is Secured
840 Illegal Output Post For Current
841 No Boost Available For Selected Output
842 Not A Valid Wideband Flatness Point
843 Wideband Flatness Cal Is Not Active
844 Report String Too Long
845 Cannot Store, Cal Is Secured
846 Range Calibration Is Not Active
847 Magnitude Too High For Range Cal
848 Magnitude Too Low For Range Cal
849 Invalid Calibrator Setup Block
850 Cannot Format, 5725 Switch In NORMAL
851 Cannot Store, 5725 Switch In NORMAL
852 Calibration Steps Out Of Order
853 Cannot Use External Guard Now
854 Cannot Use Ext Guard On Selected Range
855 Cannot Set String, Cal Is Secured
856 Present Output Exceeds Selected Limit
857 Bad Selector For Reference Calibration
858 Cannot Change Range Now
859 Hardware Not Installed For This Range
860 Cannot Use Amplifier For This Output
861 5725 Cannot Ext Sense At That Frequency
862 Change To HI Outputs For 120 A Range
1000 Could not ACK Packet From 5725
1001 Illegal 5725 Receive Task State
1002 Bad Receive Packet Number From 5725
1003 Bad Control Byte From 5725
A-6
1000-Level Faults: 5725 Communication Receive