Safety Information - Fluke 5730A/03 Operator's Manual

Multifunction calibrator
Hide thumbs Also See for 5730A/03:
Table of Contents

Advertisement

Safety Information

A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or
the equipment under test.
To prevent possible electrical shock, fire, or personal injury:
Read all safety information before you use the Product.
Carefully read all instructions.
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Use this Product indoors only.
Do not put the Product where access to the mains power
cord is blocked.
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
Do not use an extension cord or adapter plug.
Do not operate the Product with covers removed or the case
open. Hazardous voltage exposure is possible.
Do not use the Product if it operates incorrectly.
Do not connect to live output terminals. The Product can
supply voltages that can cause death. Standby mode is not
sufficient to prevent electrical shock.
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
Use only cables with correct voltage ratings.
Warnings
Introduction and Specification
Safety Information
1
1-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

5730a5730a/05

Table of Contents