Fluke 5730A/03 Operator's Manual page 78

5730A
Operators Manual
8. Enter a frequency with the numeric keypad (followed by  if necessary). The
9. Push . The Calibrator clears the entry from the entry bar near the bottom and
10. Push to activate the Calibrator output. The UUT will now respond to the
In AC current output, the selections available at the bottom are:
•
•
•
•
•
In addition, the Phase Control and Scale functions are available. The output range is
always automatically chosen and cannot be locked in ac current.
The Calibrator stays in the ac function after a non-zero frequency is
entered. To change back to dc, enter a frequency of 0 Hz or push  and
then .
4-22
display now shows the amplitude and frequency of the entry. If an entry error is
made, push  to clear the display, then reenter the value. If the most recent digit
entered is in error, push  to clear that digit. The display below assumes an entry of
2.5 kHz:
3/14/2013 10:52am
Operate
125mA 2.5kHz
External External
Sense Sense
OFF OFF
shows in the larger area above. No current is available at the output terminals until
 is pushed.
applied current.
Current Output
External Guard
Boost
Wideband
Setup Menu
+/- 0.00050mV (1 year) 213 days since calibration
Auto Range 220 mV
0.00000
External
Guard
OFF
Note
mV
Wideband Setup
Menu
OFF
hhp120.eps