Overload Measurement Specifications; Oscilloscope Connections; How To Start The Sc600 Option - Fluke 522A/6 Operator's Manual

Overload Measurement Specifications

Typical 'On' Current
Source Voltage
Indication
5 to 9 V 100 to 180 mA

Oscilloscope Connections

Using the cable supplied with the SC600 Option, connect the SCOPE output on the
Calibrator to one of the channel connectors on your oscilloscope (see Figure 9-1).
To use the external trigger, connect the TRIG OUT output on the Calibrator to the
external trigger connection on your oscilloscope. To use the external trigger and view its
signal with the calibration signal, connect the TRIG OUT output to another channel. See
your oscilloscope manual for details on connecting and viewing an external trigger.
Figure 9-1. Oscilloscope Connection: Channel and External Trigger

How to Start the SC600 Option

Press a (LED lit) to select the SC600 Option. The SCOPE menu, shown below,
appears in the Control Display. You can press any of the first four softkeys to go directly
to the VOLT, EDGE, LEVSINE, and MARKER calibration menus. Press the last softkey
to go to the OTHER menu (also shown below), allowing access to WAVEGEN, VIDEO,
PULSE, Impedance/Capacitance measurement (MEAS Z), and Overload (OVERLD)
menus. Press P to return to the SCOPE menu from the OTHER menu. This chapter
describes each of these menus in detail.
SC600 Oscilloscope Calibration Option
Typical 'Off' Current Indication
10 mA
Oscilloscope Connections
Maximum Time Limit DC or AC
(1 kHz)
Setable 1 s to 60 s
5522A CALIBRATOR
gjh036.eps
9
9-7