Table of Contents
Advertisement
More Information
For more information regarding the Delta (Δ) Amplitude and Flicker Function in Current
mode, refer to "Delta (Δ) Amplitude, Flicker Function (Volts)".
Delta (Δ) Amplitude, Single (Sags & Swells) Function (Volts)
This mode allows the user to output a single or one-time amplitude deviation. From this
mode, the user can specify the RAMP-UP time, the WIDTH of the event, and the %
deviation.
Before starting this section, refer to "Entering the PQ Modes " earlier in
this chapter.
Delta (Δ) Amplitude Mode (Volts)
Press the ΔAMPL softkey to access the Delta (Δ) amplitude functions. From this mode
the flicker and single (sags & swells) functions are accessible. The ΔAMPL Menu, shown
below, appears in the Control Display.
Press the TYPE flicker blue softkey. This will put the calibrator in the single (Sag &
Swells) Mode.
How to Set the Ramp-up Period
Press the RAMP-UP blue softkey. The Control Display changes to a screen, shown
below, instructing the user to enter the period over which the output ramps to the selected
value.
How to Set the Sag & Swell Width
The WIDTH blue softkey allows the user to specify the duration of the sag or swell event
in seconds.
How to Set the Sag/Swell Amplitude
The ΔI/I softkey allows the user to specify the amplitude of the deviation as a percentage
of the nominal output value. The value is positive for swell events and negative for sags.
Delta (() Amplitude, Single (Sags & Swells) Function (Volts)
Note
11
PQ Option
nn363f.eps
nn363f.eps
nn365f.eps
11-19
Advertisement
Table of Contents
