Chapter 6 Remote Node Tcp/Ip Configuration; Tcp/Ip Configuration; Figure 6-1 Menu 11.6 For Rfc-1483 Or Enet Encap With Vc-Based Multiplexing - ZyXEL Communications Prestige 652 User Manual

Remote Node TCP/IP Configuration
This chapter shows a sample LAN-to-LAN application and how to configure TCP/IP remote node.
6.1

TCP/IP Configuration

The following sections describe how to configure the TCP/IP parameters of a remote node.
6.1.1 Editing TCP/IP Options
Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.
In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR] to select
Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of menu 11.6 for the Prestige, depending on which encapsulation type you use and
whether you chose VC-based or LLC-based multiplexing in menu 11.1.
VC-based Multiplexing
For RFC-1483 or ENET ENCAP encapsulation with VC-based multiplexing, by prior agreement, a
protocol is assigned a specific virtual circuit, for example, VC1 will carry IP. Separate VPI and VCI
numbers must be specified for each protocol.
VC Options for IP:
VPI #= 8
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0

Figure 6-1 Menu 11.6 for RFC-1483 or ENET ENCAP with VC-based Multiplexing

Remote Node TCP/IP Configuration
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
Press ENTER to Confirm or ESC to Cancel:
VC Options for Bridge:
VPI #= 8
VCI #= 35
ATM QoS Type= 0
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBR)= 0
Prestige 652 ADSL Security Router
Chapter 6
Separate VPI and
VCI numbers
must be specified
for each protocol.
6-1