Table of Contents
Advertisement
IP Options:
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Metric= 2
Private= No
RIP Direction= Both
Multicast= IGMP-v2
IP Policies=
Figure 8-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
FIELD
NAT
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
(Network
have multiple public WAN IP addresses for your Prestige. The SMT
Address
uses the address mapping set that you configure and enter in the
Translation)
Address Mapping Set field (menu 15.1 - see section 8.3.1).
Select None to disable NAT.
When you select SUA Only, the SMT uses Address Mapping Set 255
(menu 15.1 - see section 8.3.1). Choose SUA Only if you have just
one public WAN IP address for your Prestige.
8.3
NAT Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the
SMT will use Set 1, which supports all mapping types as outlined in Table 8-2. When you select SUA
Only, the SMT will use the pre-configured Set 255 (read only).
The Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the
Prestige); a server rule must be set up inside the NAT Address Mapping set. Please see section 8.4 for
NAT
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= 2
Version= RIP-2B
Press ENTER to Confirm or ESC to Cancel:
Table 8-3 Applying NAT in Menus 4 & 11.3
Bridge Options:
Ethernet Addr Timeout (min)= 0
DESCRIPTION
Prestige 652 ADSL Security Router
OPTIONS
Full Feature
None
SUA Only
8-7
Advertisement
Table of Contents
Troubleshooting
