Table of Contents
Advertisement
Domain Name
Edit Dynamic DNS
Route IP
Bridge
3.3.1 Configuring Dynamic DNS
To configure Dynamic DNS, go to Menu 1 — General Setup and press [SPACE BAR] to select Yes in
the Edit Dynamic DNS field. Press [ENTER] to display Menu 1.1— Configure Dynamic DNS (shown
next).
General Setup
Enter your domain name here (if you have one). If you leave this field
blank, the ISP may assign a domain name via DHCP. You can go to
menu 24.8 and type "sys domain name" to see the current domain
name used by your router.
If you want to clear this field just press [SPACE BAR] and then
[ENTER]. The domain name entered by you is given priority over the
ISP assigned domain name.
Press [SPACE BAR] and then [ENTER] to select Yes or No (default).
Select Yes to configure Menu 1.1 — Configure Dynamic DNS
discussed next.
Set this field to Yes to enable or No to disable IP routing. You must
enable IP routing for Internet access.
Turn on/off bridging for protocols not supported (for example, SNA) or
not turned on in the previous Route IP field. Select Yes to turn
bridging on; select No to turn bridging off.
Menu 1.1 - Configure Dynamic DNS
Service Provider= WWW.DynDNS.ORG
Active= Yes
Host=
EMAIL=
USER=
Password= ********
Enable Wildcard= No
Press ENTER to confirm or ESC to cancel:
Figure 3-2 Configure Dynamic DNS
Prestige 652 ADSL Security Router
zyxel.com.tw
No
(default)
Yes
No
3-3
Advertisement
Table of Contents
Troubleshooting
