Ip Static Route Setup - ZyXEL Communications Prestige 652 User Manual

FIELD
(Network Select SUA Only if you have just one public WAN IP address for your
Address Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
Translation) section 8.3.1).
Select None to disable NAT.
Address When Full Feature is selected in the NAT field, configure address
Mapping Set mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see the NAT chapter for details) and type that number here.
When SUA Only is selected in the NAT field, the SMT uses NAT server
set 1 in menu 15.2 (see the NAT chapter for details).
Metric The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the cost measurement, with a minimum of
1 for directly connected networks. Type a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
Private This determines if the Prestige will include the route to this remote node
in its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are Both, In Only, Out Only or None.
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1, RIP-2B or RIP-2M.
Multicast IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
None disables IGMP.
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their
numbers separated by commas.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

6.1.2 IP Static Route Setup

Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is
directly connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected and the Prestige
has no knowledge of the networks beyond. For instance, the Prestige knows about network N2 in the
following figure through remote node Router 1. However, the Prestige is unable to route a packet to
Remote Node TCP/IP Configuration
Prestige 652 ADSL Security Router
DESCRIPTION EXAMPLE
2
2
Yes
Both
RIP-2B
IGMP-v2
3, 4, 5, 6
6-5