Remote Node Setup - ZyXEL Communications Prestige 652 User Manual

FIELD
Schedule Sets
Nailed up
Connection
Session Options
Edit Filter Sets
Idle Timeout (sec)
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
5.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors' implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
5.2

Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Remote Node Configuration
You can apply up to four schedule sets here. For more details
please refer to the Call Schedule Setup chapter.
This field specifies if you want to make the connection to this
remote node a nailed-up connection. More details are given earlier
in this section.
Use [SPACE BAR] to choose Yes and press [ENTER] to open
menu 11.5 to edit the filter sets. See the Remote Node Filter
section for more details.
Type the number of seconds (0-9999) that can elapse when the
Prestige is idle (there is no traffic going to the remote node), before
the Prestige automatically disconnects the remote node. 0 means
that the session will not timeout.
Prestige 652 ADSL Security Router
DESCRIPTION EXAMPLE
No
(default)
0
(default)
5-5