Table of Contents
Advertisement
Prestige 652 ADSL Security Router
where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the
Prestige IP address, "get" transfers the file source on the Prestige (rom-0, name of the configuration file on
the Prestige) to the file destination on the computer and renames it config.rom.
19.2.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Table 19-3 General Commands for GUI-based TFTP Clients
COMMAND
Host
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP
address when shipped.
Send/Fetch
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on
your computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or configuration
file (*.rom extension) on your computer.
Remote
This is the filename on the Prestige. The filename for the firmware is "ras" and
File
for the configuration file, is "rom-0".
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to section 19.2.5 to read about configurations that disallow TFTP and FTP from the WAN.
19.2.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1.
Display menu 24.5 and enter "y" at the following screen.
Figure 19-3 System Maintenance — Backup Configuration
19-6
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
DESCRIPTION
Firmware and Configuration File Maintenance
Advertisement
Table of Contents
Troubleshooting
