Figure 65. Parts Of The Lcd - Eaton Power Xpert 9395 550/275 Installation And Operation Manual

7 7 . . 2 2 . . 3 3 U U s s i i n n g g t t h h e e L L C C D D a a n n d d P P u u s s h h b b u u t t t t o o n n s s
The LCD on the control panel provides an operator interface with the UPS system.
display areas discussed in the following sections.

Figure 65. Parts of the LCD

A ALARM: INPUT AC UNDER VOLTAGE
INPUT
B
BATT
BYPASS
C E V E N T S METERS
D
A The UPS status area automatically scrolls between the Eaton model number, current date and time, active
alarms, active notices, and load percent and battery runtime for the UPS. If the Environmental Monitoring
Probe is installed, the temperature and humidity sensed by the probe will also be displayed. The top line of
display blinks while scrolling when the system needs attention. Some notices and alarms may be accompanied
by an audible horn. To silence the horn, press any control panel pushbutton once. Shown is a typical alarm
message. For more information about alarms and notices, see paragraph
B The information area contains data about UPS status and operations.
C The menu bar lists the titles of the available screens. To select a screen, press the pushbutton underneath
the desired screen.
D The navigation pushbuttons function depending on the screen displayed. Use the pushbuttons to select
menu screens or scroll through available screens. The LCD options above the pushbuttons indicate each
pushbutton's function.
You can use the LCD and the pushbuttons to:
• Look at a log of UPS events (alarms, notices, and commands) (see paragraph
7.2.6 Display Menu Operation).
• Monitor UPS operation (see paragraph
• Set UPS parameters (see paragraph
• Control UPS operation (see paragraphs
7.2.8 System Status Screen and
After approximately 30 minutes, the display screen darkens. To restore the screen, press any pushbutton
once.
UPS
STSW
CONTROLS
7.2.6 Display Menu
7.2.6 Display Menu
7.2.7 Load Off Screen
Controls)
Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201716—Rev 14
UPS Operating Instructions
Figure 65
OUTPUT
S E T U P LOAD OFF
7.2.2 System
Operation)
Operation)
and
identifies the
Events.
117