Omron Sysmac CS1 Operation Manual page 82

Unit Setup Area
Settings for Analog Outputs (CS1W-HCA22 Only)
Address Bits
DM 6613 00 to 07 Analog output 1
08 to 15
DM 6614 00 to 07 Analog output 2
08 to 15
Address Bits
DM 6630 00 to 07 For both analog
outputs 1 and 2
08 to 15 (Reserved by
system.)
DM 6631 00 to 15 For both analog
outputs 1 and 2
DM 6632 00 to 15 (Reserved by
to system.)
DM 6643
62
Settings Enabled at Startup
Function
Output signal range
Operation when output turned OFF
g Output signal range
Operation when output turned OFF
Settings Enabled at Startup and when Operation Starts
Function
Analog output
method
---
Adjustment mode
password
---
Details
00 Hex: –10 to 10 V
01 Hex: 0 to 10 V
02 Hex: 1 to 5 V
03 Hex: 0 to 5 V
5A Hex: Output disabled (See note.)
Note: Setting 5A can be used to
shorten the I/O refresh time.
00 Hex: Cleared
01 Hex: Held
02 Hex: Peak value
Same as for analog output 1.
Details
00 Hex: END refresh (The values stored in AR 14
and AR 15 are output as analog signals after
execution of the END instruction.)
01 Hex: Immediate refresh using instructions
(Analog signal output with execution of SPED or
ACC instruction. Output values are stored in AR 14
and AR 15 for monitoring.)
5A5A Hex: Adjustment mode enabled
Setting other than 5A5A: Adjustment mode
disabled
Section 5-1
g