Omron Sysmac CS1 Operation Manual page 103

AR Area
Address Bits
AR 18 00 Pulse Output 1 Status
01
02
03
04
05
06
07
Function
Pulse Output
Completed Flag
Number of
Pulses Specified
Flag
PLS2 Target
Frequency Not
Reached
Target
Comparison in
Progress
Independent
Pulse Output In
Progress
Positioning In
Progress (PLS2)
Accelerating/
Decelerating
Pulse Output In
Progress
Details
OFF: Pulse output not Unit
completed (stays OFF
during pulse output).
ON: Pulse output
completed (goes ON
at completion of pulse
output)
OFF: Number of
pulses has not been
set using PULS.
ON: Number of pulses
has been set using
PULS.
OFF: Normal
ON: Pulse output has
decelerated without
reaching the target
frequency when PLS2
is executed or during
pulse output.
OFF: Stopped
ON: In progress
OFF: No output, or
continuous output
ON: Output in
progress
OFF: Positioning not
in progress
ON: Positioning in
progress
OFF: No output, or
output at a constant
frequency
ON: During
acceleration or
deceleration using
ACC or PLS2.
OFF: Pulse output
stopped
ON: Pulse output in
progress
Section 6-4
Controlled Forced
by set/reset
Enabled
83