Omron Sysmac CS1 Operation Manual page 101

AR Area
Address Bits Function
AR 09 08 High-speed
counter 2
commands
09
10
11
12
13 to (Reserved
15 by
system.)
High-speed
AR 10 00 to
counter 1
15
monitor
data
AR 11 00 to
15
High-speed
AR 12 00 to
counter 2
15
monitor
data d t
AR 13 00 to
15
Details
High-speed Same as for high-speed counter 1
Counter commands.
Start Bit
High-speed
Counter
Reset Bit
Measure- Same as for high-speed counter 1
ment Start commands except that frequency
Bit (mea- measurement is not possible with counter
surement 2.
mode 1)
(Reserved by system.)
Range Same as for high-speed counter 1
Comparison commands.
Result Clear
Bit
--- ---
Range The instruction execution result that is
comparison output when the CTBL instruction is
result executed for a range comparison is stored
here.
Bits 00 to 15: ON for each condition (from 1
to 16) that is satisfied.
OFF: Condition not satisfied
ON: Condition satisfied
Output bit The output bit pattern that is output when
pattern the CTBL instruction is executed for a
range comparison is stored here.
Note: When more than one condition is
satisfied, the logical OR of all the output
patterns that satisfy the conditions is set.
Same as for high-speed counter 1 monitor
Range
data.
comparison
result
Output bit
pattern
Section 6-4
Controlled Forced
by set/reset
User Enabled
Unit
81