Omron Sysmac CS1 Operation Manual page 106

AR Area
Analog Outputs (CS1W-HCA22 Only)
Address Bits
AR 14 00 to 15 Analog Output 1
Output Value
AR 15 00 to 15 Analog Output 2
Output Value
AR 16
00 Analog Output 1
Conversion Enable
Bit
01 Analog Output 2
Conversion Enable
Bit
02 to 15 (Reserved by system.)
86
Function
If END refresh is set as the analog output
method, the value set here by the user in
4-digit hexadecimal is output from analog
output 1 when analog output is refreshed.
If immediate refresh using instructions is set
as the analog output method, the value
output from analog output port 1 is stored
here in 4-digit hexadecimal for monitoring
when analog output is refreshed.
0 to 10 V, 0 to 5 V, 1 to 5 V:
–10 to 10 V:
Note 1: The analog output method (END
refresh or immediate refresh using
instructions) is specified in bits 00 to 07 of
DM 6630 in the Unit Setup Area (00 Hex:
END refreshing). The setting applies to both
analog outputs 1 and 2.
Note 2: The output signal range is specified
in DM 6613.
Same as above (except that analog output 2
is used for analog output and the output
signal range is set in DM 6614).
ON: D/A conversion enabled (an analog
signal is output)
OFF: D/A conversion is not performed
(analog output is held at the value specified
in DM 6613 and DM 6614) in DM 6613 nd DM 6614)
Note: These bits are cleared when the
Customizable Counter Unit's operating
mode is switched between RUN or
MONITOR mode and PROGRAM mode.
Details
FF38 to 1068 Hex
EA84 to 157C Hex
Section 6-4
Controlled Forced
by set/reset
Immediate Enabled
refresh
using
instructions:
Unit
END
refresh:
User
User