Omron Sysmac CS1 Operation Manual page 107

AR Area
Address Bits
AR 17 00 Analog Output 1
User Adjustment
Flag
01 Analog Output 2
User Adjustment
Flag
02 to 03 (Reserved by system.)
04 Analog Output 1
Operation In
Progress
05 Analog Output 2
Operation In
Progress
06 to 07 (Reserved by system.)
08 Analog Output 1
Output SV Error
09 Analog Output 2
Output SV Error
10 to 11 (Reserved by system.)
12 Analog Output 1
Factory Setting
Adjustment Error
13 Analog Output 2
Factory Setting
Adjustment Error
14 Analog Output 1
User Adjustment
Error
15 Analog Output 2
User Adjustment
Error
Function
The default setting is OFF. When offset/gain
adjustment is performed by the user, these
bits turn ON, and when the adjustment
values are cleared and reset to their factory l
settings these bits return to OFF.
ON: Analog output is being changed using
the ACC instruction.
OFF: Analog out ut has reached the target OFF: Analog o tp t has reached the target
value.
ON: A value that exceeds the allowable
range has been set for analog output SV.
OFF: The values set for analog output SV OFF: The values set for analog out ut V
lie within the allowable range.
Note: This bit is valid only when the analog
output method is set to END refresh.
ON: There is an error in the factory-set data
stored in FROM.
OFF: There are no errors in the factory-set OFF: There are no errors in the factory-set
data stored in FROM.
ON: There is an error in a user adjustment
value stored in FROM.
OFF: There are no errors in the user OFF: There are no errors in the ser
adjustment values stored in FROM.
Details
, j
l d d t t th i f
Section
Controlled Forced
by set/reset
Unit Enabled
t
6-4
87